It’s dry out there. We had pretty good moisture over the winter months, but the early spring has been unseasonably warm (OK!) and dry. We’ve come to expect that in New Mexico, and a few days ago, I wrote about the wildfire danger. Today, let’s review a few tips for water-wise spring landscaping that help homeowners here and just about anywhere in the country where drought can be an issue.
- Set out your rainwater harvesting system. If you live in a climate zone that’s warm enough to leave rain barrels out all winter or have underground cisterns, your system has been efficiently gathering water all winter. In other climates, rain barrels can freeze in winter. Ours are on the south side of the house and should be past danger of long and hard freeze. Now, all we need is rain.
- Update your irrigation system to a low-volume method. The most practical and water-efficient way to hydrate ornamentals is with drip irrigation. When you use spray heads, water evaporates into the air. It also hits leaves and nearby plants. The spray can cause leaf disease in some plants, plus it’s more efficient to soak roots deeply than to water the entire plant.
- As you plan your irrigation, or check out your current system this spring, make sure to adjust the water amount for the plants or areas where you have bubblers. For example, succulents and many xeric plants need no water at all once established, unless you’re in an extreme drought. You can cap those bubblers off. Too much water can actually harm some xeric plants. Use drips at the base of low- and medium-water flowers and groundcovers. Increase the flow rate for larger shrubs and trees, and add a few extra emitters around trees, especially while they’re becoming established. Remember that tree roots grow out, just like the canopy.
- Water in the morning to get your plants through the heat of the day, and when less evaporation occurs.
- Use raised beds. Raised beds and containers concentrate water, so if you want a few herbs or vegetables or some medium- to high-water ornamentals, confine them to an area that takes a little more water than the others. If you place the raised bed near your drip system, you can add it to the mix and adjust the flow on your emitter if necessary. Just remember, some containers, such as clay pots, dry out more quickly, even though they use less water each time. It’s like having a smaller tank on a fuel-efficient car. It’s not necessarily using more gas, just needing more frequent refilling.
- When adding plants to your garden, build a small well around them to hold water. This helps the plant soak up the irrigation and keeps water from running down and off the plant, wasting your precious resource.
- Use mulch when possible to help retain water and keep roots cool during the heat of the summer.
Finally, automatic irrigation is most efficient, and the consistent, timed watering is best for plants and lawns. But override it whenever you can after a good rain. I used to bemoan the waste when my neighbor’s sprinklers would come on as scheduled while their lawn already glistened with rainwater.